Your article Something not working on Windows? Try the following says:
Download a fresh copy of AMPSetup.msi - and run it in Repair mode.
However, it doesn’t say HOW to run it in Repair mode and this is not one of the options when you run the installer.
I searched everywhere on CubeCoders and the only other references I found were others noting that these instructions are not provided.
I also couldn’t find any explanation on Windows or MSI specific sites after a reasonable amount of Googling, so this isn’t readily available knowledge.
MSI does reference “/fa” Force Install All option, but this can be quite different from a repair, so isn’t immediately intuitive as the appropriate option either.
Thanks!